1.Complete the
Attention:
a.The power switch on the power supply and fan unit does not turn off the electrical current supplied to the device. The DS4700 Express Storage Subsystem might also have more than one connection to dc power. To remove all electrical current from the device, ensure that all dc power cords are disconnected from the power supply and fan unit dc input connectors.
b.For a DS4700 Express Storage Subsystem with dc power supply and fan units only, turn off all of the attached disconnect devices. IBM recommends that you use the disconnect device to remove power before disconnecting the dc power cord.
2.Label and remove the power cords from the power supply and fan units of the DS4700 Express Storage Subsystem.
3.Label the fibre channel cables that are attached to the rear of the controllers. Labeling the cables simplifies the
4.Remove the fibre channel cables that are attached to the rear of the controllers.
5.Remove both controllers. To remove them do the following:
a.Squeeze the controller latch and pull the lever open 90° (so that the lever is horizontal) to release the controller from the latch. The controller latch is a coral colored tab on the lever.
Note: The lever rotates upward or downward 90°, depending on whether the controller you are removing is the right or left controller CRU.
b.Slowly pull the lever away from the storage subsystem chassis to remove the controller from the controller bay, as shown in Figure 21 on page 42. (Remove the controllers from the chassis and place it on electrostatic discharge (ESD) protected surface.)
c.Repeat steps 5a and 5b for the other controller.
6.Remove both power supply and fan units. To remove them, do the following:
a.Squeeze the latch and pull the lever open 90° (so that the lever is horizontal) to release the power supply and fan unit from the latch. The latch is a coral colored tab on the lever.
b.Slowly pull the lever away from the chassis to remove the power supply and fan unit, as shown in Figure 22 on page 43. (Remove the power supply and fan unit from the chassis and place it on ESD protected surface.)
Note: The lever rotates upward or downward 90°, depending on whether the power supply and fan unit you are removing is in the right or left power supply and fan unit bay.
c.Repeat steps 6a and 6b for the other power supply and fan unit.
7.Remove the Telco bezel if it is installed. See “Removing and replacing a bezel” on page 150 for instructions.
8.Label the Enhanced Disk Drive Module
9.Remove the