Exchanging the memory

See “Resolving hardware problems” on page 31 to determine whether or not it is necessary to replace the logic unit, or any other parts. For information on ordering thin client hardware parts, refer to “Replacing parts other than the N2800e CompactFlash card” on page 42. Complete the procedure, “Removing the logic unit to install parts” on page 45 before performing the following Dual Inline Memory Module (DIMM) procedures:

1.To remove a DIMM from the logic unit, press the two

tabs located at each end of the DIMM out and down.

2.To install a DIMM into the logic unit, align the notches

on the bottom of the DIMM

with the notched areas

on the memory socket.

 

 

 

3. Press down firmly on the center of DIMM

until the

memory socket tabs

flip up.

 

 

4.See “Reassembling the thin client” on page 45.

Exchanging the lithium battery

Read “Caution notices” on page vi, and see “Removing the logic unit to install parts” on page 45 before continuing.

1.To remove the battery, place your thumb on the battery and lift it up with your index finger.

2.Dispose of the used battery according to your local regulations.

3. Install the new battery into the battery socket

, with

the +sign facing up.

 

4.See “Reassembling the thin client” on page 45.

Note: If you receive an error message on your screen after performing this procedure, see “Resolving hardware problems” on page 31.

Appendix B. Hardware maintenance procedures 47

Page 57
Image 57
IBM N2800e manual Exchanging the memory, Exchanging the lithium battery