Removing the power supply:

Notes:

1.Only IBM-authorized personnel should remove the power supply.

2.You will need a Phillips head screwdriver for the following procedure.

1.Complete the procedure, “Removing the logic unit to install parts” on page 45 before continuing.

2. Disconnect the power supply connector

from

the logic board.

 

Pinch the top of the power supply connector as you disconnect it from the logic board. This releases the power supply connector latch.

3.

Remove the two screws

attaching the support

 

plate

to the power supply

.

4.

Pull the support plate

out of the logic unit and

 

set it aside.

 

 

5.

Remove the three screws

attaching the power

 

supply to the logic unit.

 

 

6.Push the power supply toward the front of the logic unit until it stops.

7.Carefully remove the power supply from the logic unit.

8.Continue with the procedure, “Installing the power supply” on page 49.

48

Page 58
Image 58
IBM N2800e manual Removing the power supply