7529_eng.fm Page 7 Wednesday, November 12, 2003 8:57 AM
How to use this Manual
This manual is split into sections describing the steps to be taken to configure the ETA for use in measuring and recording torque values.
There are a number of other parameters which are set from the Software Reset Menu, some of which are detailed elsewhere in this manual.
Pressing Enter after making a selection will take the user on to the next screen.
Pressing MENU will give the user the option to exit to the Misc menu or continue to edit by
pressing 
.
Screens can be skipped using the 
and 
keys.
The following method is adopted throughout this manual.
Keys to be pressed will be shown as the key legend in large type: Example Enter
Any special instructions or point to note will be shown as:
Enter
INSTRUCTION TO BE FOLLOWED
Refer to the table of contents to find action to be performed.
Follow instructions for key presses required to carry out required action.
Note: It is possible to change the default primary character on dual function keys. ie: when text is entered into various fields, it is possible to set the ETA to default to either the numerals or text as the primary char- acter (the alternate character is selected by pressing the shift key before typing). To set this:
From main menu:
Press | then press | 6 |
Press | then press | 6 |
(Misc)
(Software Reset)
Press the 
7 times to access the ‘Shift key’ menu Select between options 1 ‘Characters’ or 2 ‘Numbers’ using: 
Press | MENU | Screen will prompt “End of setup” |
Press | MENU | MENU to return to main menu |
7
