7529_eng.fm Page 17 Wednesday, November 12, 2003 8:57 AM
Direct Measure Mode - ETA5 ONLY
Crane UTA Type Transducers)
Direct measure mode allows an operator to connect different transducers which may have differ- ent spans and an angle output, and can switch between them using an external T switch. This is a display only function and readings are not stored or printed out.
To start, press | ON |
|
|
press | MENU |
|
|
press | 4 | (Direct) |
|
press | 1 | (Direct Measure) | |
press | 1 | (Setup) |
|
select units of measure using |
| ; press | Enter |
select peak, track, Impulse or ‘Click Dip’ using | ; press Enter | ||
select measurement direction using 
(Right is clockwise. Left is
press Enter
select ‘Cycle end Time’ using | ; press | Enter |
|
select frequency response using | ; press | Enter |
|
type in the Threshold Percent (mx 50.0; mn 0.0), and press | Enter | ||
type in amount of Click (mx 100.0 Nm; mn 0.0 Nm), and press | Enter | ||
select ‘Second Parameter’ using | ; press | Enter |
|
Screen shows “End of Setup”, press | MENU to exit |
|
|
press MENU MENU to return to main menu
17
