Integra DTR-7.4 Selecting the Appropriate Setting for Your Connections, Surr Back/Zone 2 Sub-menu

Selecting the Appropriate Setting for Your Connections—Continued

Surr Back/Zone 2 Sub-menu

0-2.Surr Back/Zone2

a.Surr Back/Zone2 :Zone2

Quit:[SETUP]

a. Surr Back/Zone 2

Zone 2: Select when connecting the speakers for the remote zone (Zone 2) to the SURR BACK/ZONE 2 PRE OUT or SURR BACK/ZONE 2 SPEAKERS terminals (for using the internal amplifier for Zone 2). Surr Back (default): Select when not connecting the speakers for the remote zone (Zone 2) to the SURR BACK/ZONE 2 PRE OUT or SURR BACK/ ZONE 2 SPEAKERS terminals (for using the inter- nal amplifier for the surround back speakers).

Note:

The SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER terminals

In order to have 7.1 channel playback in the main room, you must set the Surr Back/Zone 2 setting to “Surr Back.” When set to “Surr Back,” the surround back signals are output from the SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER terminals. Connect the surround back speakers to the SURR BACK/ZONE 2 SPEAKER terminals or to the speakers terminals of the power amplifier connected to the SURR BACK/ZONE 2 PRE OUT terminals.

When you are not using the surround back speakers in the main room and are using the internal amplifier to power the speakers for the remote zone (Zone 2), set the Surr Back/ Zone 2 setting to are “Zone 2.” When set to “Zone 2,” the Zone 2 signals are output from the SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER terminals. Connect the remote zone (Zone 2) speakers to the SURR BACK/ZONE 2 SPEAKER terminals or to the speaker terminals of the power amplifier connected to the SURR BACK/ZONE 2 PRE OUT terminals.

At this time, the main room is switched to 5.1 channel playback mode, and therefore you cannot select the THX Surround EX, Dolby Digital EX or DTS-ES, which requires the surround back speakers.

Remote Setup Sub-menu

Use this sub-menu when you have a remote control sensor connected to the IR IN terminal. The setting in this sub-menu tells the DTR-7.4 whether the remote control sensor is being used for operation of the DTR-7.4 in the main zone or the remote zone (Zone 2).

0-3.Remote Setup
a.Position	:Main
b.Remote ID	:1
	Quit:[SETUP]

a. Position

Main: Select when you are using the remote control sensor for operation with the remote controller in the main zone.

Zone 2: Select when you are using the remote control sensor for operation with the remote controller in the remote zone (Zone 2).

b. Remote ID

This section explains how to change the DTR-7.4’s remote control ID. You may need to change this if the DTR-7.4’s remote controller interferes with other Integra/Onkyo components located in the same room.

Note:

If you change the DTR-7.4’s remote control ID, be sure to select the same ID on the remote controller (See the next section). The default ID for both the DTR-7.4 and remote controller is 1.

Setting Up Your DTR-7.4

31