Integra Playing Analog Multichannel Audio, of Your DTR-7.4, Changing the listening mode

Enjoying Analog Multichannel Audio Playback—Continued

Playing Analog Multichannel Audio

Before enjoying analog multichannel audio, make sure that the connections and settings shown on the previous page are completed.

The illustrations used here represent the remote control- ler. When you perform the procedures on the DTR-7.4, use the corresponding buttons on the front panel.

Note:

The speaker level for each multichannel analog input is independent from the speaker level settings made with the test tone. Therefore, you should perform the proce- dures above before enjoying analog multichannel audio.

Changing the listening mode

1 Input	Press the Input button, and then
	roll the scroll wheel to select
	“DVD.”

Pure A Direct

Each time you press the Direct/ Pure Audio button on the front panel, the display changes between “Direct” “Pure Audio.” When using the remote controller, press Pure A or Direct.

Using the tone control

2	Press the scroll wheel, and then
	press the Audio SEL button
	repeatedly to select “Multich.”
	On the DTR-7.4, use the Audio
	Selector button.
	Audio SEL
3	Turn on the connected component
	and start playing the desired media.
4	Adjust the volume with the Master

1

DTR-7.4

Surround

Remote controller

Surround

Press the Surround button on the front panel or the remote control- ler to display “Tone On.”

of Your DTR-7.4

	Volume dial (or the VOL	but-
VOL	tons on the remote controller).

Adjusting the output level of each speaker as desired

Using the remote controller:

1		Press the scroll wheel.
2	CH SEL	Press the CH SEL button and
		select the desired speaker.
3		Press the Level – or + button to
Level - Level +		adjust the volume level.

Adjust the volume at each speaker so that all the volumes sound at the same level at the listening position. For the front right, front left, center, surround right, sur- round left, surround back right, and sur- round back left speakers, the output levels can be adjusted between –12 and +12 decibels. The subwoofer can be adjusted between –30 and +12 decibels.

2	Adjust the bass and treble sounds.
	Select “Setup Menu” → “Audio Adjust
	Menu” → “Tone Control” to display the
	“Tone Control” sub-menu and perform
	the bass and treble settings. For details,
	see page 54.

To disable the tone control function:

Press the Direct/Pure Audio button on the front panel (or the Direct button on the remote controller).

Making Full Use

65