Enjoying Music or Videos with the DTR-7.4

Enjoying Music or Videos with the DTR-7.4—Continued

Temporarily Changing the Speaker Output Levels

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be

Using the Sleep Timer (remote controller only)

With the sleep timer you can set the DTR-7.4 so that it automatically turns off after a set period.

set between –12 and +12 decibels (between –15 and +12 decibels for the subwoofer). Note that the speaker volumes will return to the original settings when the DTR-7.4 is put in the standby state.

1	Press the scroll wheel.

2	Press the CH SEL button and

CH SEL	select the desired speaker.

3	Press the Level – or + button to

Level - Level +	adjust the volume level.

Notes:

•You cannot select a speaker if it is set to “No” or “None” in the Speaker Conﬁg Sub-menu of the Speaker Setup Menu.

•To have your new speaker levels set here, overwrite the settings at Setup Menu → Speaker Setup Menu → Level Calibration Sub-menu, and press the Test Tone button after you complete step 3 in the proce- dure above.

Remote controller

Sleep

Press the scroll wheel, and then press the Sleep button repeatedly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute increments.

The Sleep indicator appears on the dis- play when the sleep timer has been set, as shown. The speciﬁed sleep time appears on the display for about ﬁve sec- onds, then the previous display reap- pears.

To cancel the sleep timer, press the Sleep button repeatedly until the Sleep indicator disappears.

To check the remaining sleep time,

press the Sleep button. Note that if you press the Sleep button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

Using the sleep timer only for Zone 2:

If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with main zone turned on and then put the main zone into the standby state.

Enjoying Music and Movies

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-7.4 using the Dimmer button on the remote con- troller or on the DTR-7.4 front panel (other than Euro- pean models).

DTR-7.4

Dimmer

Remote controller

Use the Dimmer button on the DTR-7.4 to select: dim, dimmer, or normal brightness.

On the remote controller, press the scroll wheel, and then press the Dimmer button.