Installing and Replacing Mobile Board Components
49
Attaching the Lid/LCD
This section describes how to attach the lid/LCD to the chassis and connect the
associated cables. See Figure 18 and follow these steps:
1. Observe the precautions in "Before You Begin" on page 35.
2. Place the Lid/LCD hinges over the matching holes in the chassis. Note that each
hinge has an alignment pin. Attach the hinges (Figure 18, A) with two screws as
shown in the figure.
3. Connect the LCD video cable connector (Figure 18, C) to the LVDS connector
(Figure 18, D) on the Mobile Board.
4. Route the three antenna cables (Figure 18, E) under the C-plate to the Mobile
Board. These cables will be connected in a later section.