Intel PXA26X 6.7 Synchronous Static Memory Interface

6-30 Intel® PXA26x Processor Family Developer’s Manual
Memory Controller
6.7 Synchronous Static Memory Interface
The synchronous static memory interface supports SMROM and non-SDRAM-li ke flash
memories. The synchronous static memory can b e co nfi gu red fo r a ny o f the n CS[ 3:0] sign als . Chi p
Select 0 must be used for boot memory. Syn chrono us stati c memor ies in ba nk pa irs 1/ 0 or 3/ 2 must
be set to the same timing.
If any of the nCS[3:0] banks are configured for Synchronous Static Memory via
SXCNFG[SXENx], the corresponding half-words of MSC0 (see Section 6.8.2, “Asynchronous
Static Memory Control Registers (MSC0 – 2)”) and MSC1, except the data width in
MSCx[RBWx], are ignored.
6.7.1 Synchronous Static Memory Configuration Register
All synchronous static memory is controlled by the read/write SXCNFG regis ter. Refer to
Table 6 -14. SXCNFG[15:0] configures chip select signals 0 and 1. SXCNFG[31:16] configures
chip select signals 2 and 3.
Table 6-14. SXCNFG Reg ister Bitmap (Sheet 1 of 6)
4800 001C SXCNFG
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Reserved
SXLATCH2
SXTP2
SXCA2 SXRA2
SXRL2 SXCL2
SXEN2
Reserved
SXLATCH0
SXTP0
SXCA0 SXRA0
SXRL0 SXCL0
SXEN0
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 * * * * * * * * * * * * * 0 *
Bits Name Description
31 — Reserved
30 SXLATCH2
SXMEM LATCHING SCHEME FOR PAIR 2/3:
0 – Latch return data with fixed delay on MEMCLK
1 – Latch return data with return clock
Must be set to a 1 to enable the return clock SDCLK for latching data. For more details on
this return data latching.
29:28 SXTP2
SX MEMORY TYPE FOR PARTITION PAIR 2/3:
00 – Synchronous Mask ROM (SMROM)
01 – Reserved
10 – Non-SDRAM-like synchronous flash
11 – Reserved
27:26 SXCA2
SX MEMORY COLUMN ADDRESS BIT COUNT FOR PARTITION PAIR 2/3:
00 – 7 column address bits
01 – 8 column address bits
10 – 9 column address bits
11 – 10 column address bits