Intel Raptor AT manual Winbios

		Appendix D: Industrial Devices
Checkpoint			Description
Code
	The keyboard controller interface test completed.
82h	Writing the command byte and initializing the circular
	buffer next.
	The command byte was written and global data
83h	initialization has completed. Checking for a locked key
	next.
84h	Locked key checking is over. Checking for a memory
	size mismatch with CMOS RAM data next.
	The memory size check is done. Displaying a soft error
85h	and checking for a password or bypassing WINBIOS
	Setup next.
86h	The	password was	checked. Performing			any required
	programming before WINBIOS Setup next.
	The programming before WINBIOS Setup has
87h	completed. Uncompressing the WINBIOS Setup code
	and executing the AMIBIOS Setup or WINBIOS Setup
	utility next.
	Returned from WINBIOS Setup and cleared the screen.
88h	Performing any necessary programming after WINBIOS
	Setup next.
89h	The programming after WINBIOS Setup has completed.
	Displaying the power on screen message next.
	The first screen message has been displayed. The
8Bh	<WAIT...> message is displayed. Performing the PS/2
	mouse check and extended BIOS data area allocation
	check next.
8Ch	Programming the WINBIOS Setup options next.
8Dh	The	WINBIOS	Setup	options	are	programmed.
	Resetting the hard diskcontroller next.
8Fh	The hard disk controller has been reset. Configuring the
	floppy drivecontroller next.
91h	The	floppy drive	controller has		been	configured.
	Configuring the hard disk drive controller next.
95h	Initializing the bus option ROMs from C800 next. See
	Table D-7for additional information.
96h	Initializing before passing control to the adaptor ROM
	at C800.
97h	Initialization before the			C800 adaptor		ROM gains
	control has completed. The adaptor ROM check is next.

63