Intel Raptor AT manual 3Ah

Appendix D: Industrial Devices

Checkpoint			Description
Code
37h	The display mode		is set. Displaying		the power	on
	message next.
38h	Initializing the bus input, IPL, general devices next, if
	present. See Table D-7for additional information.
39h	Displaying bus initialization error messages. See Table
	D-7for additional information.
3Ah	The new	cursor position		has been read and saved.
	Displaying the Hit <DEL> message next.
3Bh	The Hit <DEL> message is displayed. The protected
	mode memory test is about to start.
40h	Preparing the descriptor tables next.
42h	The descriptor tables are prepared. Entering protected
	mode for the memory test next.
43h	Entered	protected	mode.	Enabling	interrupts	for
	diagnostics mode next.
	Interrupts enabled if the diagnostics switch is on.
44h	Initializing data to check memory wraparound at 0:0
	next.
45h	Data initialized. Checking			for memory wraparound		at
	0:0 and finding the total system memory size next.
	The memory wraparound test is done. Memory size
46h	calculation has been done. Writing patterns to test
	memory next.
	The memory pattern has been written to extended
47h	memory. Writing patterns to the base 640 KB memory
	next.
48h	Patterns	written in	base	memory. Determining		the
	amount of memory below 1 MB next.
	The amount of memory below 1 MB has been found and
49h	verified. Determining the amount of memory above 1
	MB memory next.
	The amount of memory above 1 MB has been found and
4Bh	verified. Checking		for a soft reset and clearing			the
	memory below 1 MB for the soft reset next. If this is a
	power on situation, going to checkpoint 4Eh next.
4Ch	The memory below 1 MB has been cleared via a soft
	reset. Clearing the memory above 1 MB next.
	The memory above 1 MB has been cleared via a soft
4Dh	reset. Saving the memory size next. Going to checkpoint
	52h next.

61