Intel SBX82 manual Removing the blade server bezel assembly, Statement

Complete the following steps to open the blade server cover:

1.Read the safety information beginning on page “Safety” on page vii and “Installation guidelines” on page 19.

2.Carefully lay the blade server down on a flat, non-conductive surface, with the cover side up.

3.Press the blade-cover release on each side of the blade server and lift the cover open, as shown in the illustration.

4.Lay the cover flat, or lift it from the blade server and store for future use.

Statement 21:

xxCAUTION:

Hazardous energy is present when the blade server is connected to the power source. Always replace the blade cover before installing the blade server.

Removing the blade server bezel assembly

To install certain options, you must first remove the blade server bezel assembly. The following illustration shows how to remove the bezel assembly from the blade server.

Bezel-assembly release

Bezel-assembly
release	Control-panel
Control panel
	cable
connector

Complete the following steps to remove the blade server bezel assembly:

1.Read the safety information beginning on page “Safety” on page vii and “Installation guidelines” on page 19.

2.Open the blade server cover (see “Opening the blade server cover” on page 20 for instructions).

3.Press the bezel-assembly release and pull the bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).

4.Disconnect the control-panel cable from the control-panel connector.

5.Pull the bezel assembly away from the blade server.

6.Store the bezel assembly in a safe place.

21