a.Install the expansion card tray. Secure the tray to the system board with the screws from the option kit, as shown Figure 11.

b.Orient the expansion card and slide the notch in the narrow end of the card into the raised hook on the tray; then gently pivot the wide end of the card into the expansion card connectors.

NOTE

For device driver and configuration information to complete the installation of the expansion card, see the documentation for the option.

7.If you have other options to install or remove, do so now; otherwise, go to “Completing the installation” on page 43.

IInstalling the Intel Blade Server SCSI Expansion Module

SBESCSI

The Intel® Blade Server SCSI Expansion Module SBESCSI supports up to two hot-swap SCSI hard disk drives and up to two standard form-factor I/O cards or two small form-factor I/O cards.

To help ensure proper cooling and system reliability, make sure that:

Each of the blade bays on the front of the SBCE unit has either a blade server or filler blade installed.

A removed hot-swap blade server or filler blade is replaced within 1 minute of removal.

Each of the SCSI hard disk drive bays on the SCSI storage expansion unit contains either a hot- swap SCSI hard disk drive or a filler panel.

SBCE SCSI Storage

Expansion Unit

Filler panels

Attention: Static electricity can damage electronic devices and your blade server. To avoid damage, keep static-sensitive devices in their non-conductive packages until you are ready to install them.

32

Intel Server Compute Blade SBX82 Installation and User’s Guide

Page 46
Image 46
Intel SBX82 manual IInstalling the Intel Blade Server Scsi Expansion Module, Sbescsi