
6.Install the SCSI storage expansion unit:
a.Touch the
b.Orient the expansion unit as shown in the illustration.
c.Lower the expansion unit so that the slots at the rear slide down onto the pins at the rear of the blade server.
d.Pivot the expansion unit closed and press it firmly into place until the
Statement 21:
xxCAUTION:
Hazardous energy is present when the blade is connected to the power source. Always replace the blade cover before installing the blade.
7. Insert the combined blade server and expansion unit into two adjacent bays in the SBCE unit.
✏NOTE
When any blade server or option is in blade bay 7 through 14, power modules must be present in power bays 1, 2, 3, and 4.
8.Turn on the blade server.
9.If you have not already done so, install the LSI device drivers for your operating system.
With the expansion unit installed on your blade server, you can install up to two
SCSI hard disk drive 1 is in the top bay in the expansion unit; SCSI hard disk drive 2 is the bottom bay.
Table 4. SCSI IDs for the hard disk drives in the expansion unit
Device | SCSI ID | |
|
|
|
SCSI hard disk drive 1 | (blade server) | 0 |
|
|
|
SCSI hard disk drive 2 | (blade server) | 1 |
|
|
|
SCSI hard disk drive 1 | (expansion unit) | 2 |
|
|
|
SCSI hard disk drive 2 | (expansion unit) | 3 |
|
|
|
35