![](/images/new-backgrounds/1314505/31450579x1.webp)
•The processor sockets in this server contain
•The processor speeds are automatically set for this server; therefore, you do not have to set any processor
The following illustration shows how to install the second processor on the system board for the blade server.
Alignment marks | Heat sink |
Microprocessor
Heat sink filler
Microprocessor locking lever
Complete the following steps to install an additional processor:
1.Read the safety information beginning on page “Safety” on page vii and “Installation guidelines” on page 19.
2.Shut down the operating system, turn off the blade server, and remove the blade server from the SBCE unit (see “Installing and removing the blade server from the SBCE unit” on page 20 for instructions).
3.Carefully lay the blade server on a flat,
4.Open the blade server cover (see “Opening the blade server cover” on page 20 for instructions).
5.Remove the bezel assembly (see “Removing the blade server bezel assembly” on page 21 for instructions).
6.Locate the processor socket on the system board.
7.Remove the
8.Install the processor:
a.Remove the protective cover, tape, or label from the surface of the processor socket, if one is present.
b.Touch the
Attention: Do not use any tools or sharp objects to lift the locking lever on the processor socket. Doing so might result in permanent damage to the system board.
26 | Intel Server Compute Blade SBX82 Installation and User’s Guide |