Mode Adjust | JBL Performance |
PANORAMA
MODE ADJUST 
PANORAMA
•Designed for playback of stereo and
•Uses proprietary algorithms to move the stereo image out- ward from the front speakers, producing a wider stereo field with greater depth.
•Depends on proper location of the listening position and front speakers. When the front speakers are positioned close to either side of the display device, the effect is produced over a wider area than when the front speakers are positioned at a large angle from the display device.
Option/Parameter | Default Setting | Possible Settings |
|
|
|
EFFECT LVL | +4dB | |
|
|
|
BASS CONTENT | STEREO | BINAURL, MONO, STE- |
|
| REO |
|
|
|
LOW FREQ WIDTH | +0 | |
|
|
|
SURR ROLLOFF | 3.1kHz | 500Hz to 20.0kHz, OFF |
|
|
|
REAR DLY OFFSET | 15ms | OFF, 1ms to 30ms |
|
|
|
INPUT BALANCE | <> | L< to <> to >R |
|
|
|
CALIBRATION | ||
|
|
|
OUTPUT LEVELS | ||
|
|
|
CUSTOM |
See “Listening Mode Menu Option & Parameter Descriptions” on page
PANORAMA CALIBRATION
MODE ADJUST 
PANORAMA 
CALIBRATION
•The PANORAMA listening mode must be calibrated to take full advantage of its effects.
•For best results, it is recommended that you center the pri- mary listening position between the front left and right speak- ers as shown in the illustration centered at the top of page 5- 14. Otherwise, the PANORAMA listening mode will be cali- brated with various results.
Option/Parameter | Default Setting | Possible Settings |
|
|
|
SOURCE | LEFT & RIGHT | RIGHT, LEFT & RIGHT, LEFT |
|
|
|
SPEAKER ANGLE | 30deg | 10deg to 90deg |
|
|
|
LISTENER POS | +0 |
See “Listening Mode Menu Option & Parameter Descriptions” on page
To calibrate the PANORAMA listening mode:
1.Remove all obstructions between the speakers and the primary listening position.
2.Make sure the distances between the speakers and the primary listening position are properly measured. Then, enter these dis- tances on the SPEAKER DISTANCES menu.
3.Sit in the primary listening position. If the primary listening posi- tion is not centered between the front left and right speakers, set the LISTENER POS parameter to compensate for the difference.
4.Set the SOURCE parameter to RIGHT.
5.Begin playback of the calibration source. It is recommended you use a familiar stereo.
