AV1 | Troubleshooting & Maintenance |
The AV1 is powered on, but there is no video.
1.Examine the video cables – particularly the
2.Check the INPUT SETUP menu VIDEO IN (page
RF interference is present in the audio or video.
1.Make sure the AV1 is not positioned near unshielded TV or FM antennas, cable TV decoders, and other
2.Replace unshielded cables with shielded cables wherever possible.
The AV1 is exhibiting erratic behavior.
1.Set the rear panel power switch to the (“off”) position. Wait 10 seconds. Then, set the rear panel power switch to the c (“on”) position.
2.Document all
If all else fails . . .
1.Set the rear panel power switch to the (“off”) position. Wait 10 seconds. Then, set the rear panel power switch to the c (“on”) position.
2.Document all
3.Contact an authorized JBL Performance dealer.
4. Contact JBL customer service at
Note:
Visit www.jbl.com for additional troubleshooting information.
ROUTINE MAINTENANCE
The bulleted items below describe routine maintenance that should be performed on a periodic basis.
•Clean the AV1 exterior surface with a soft,
•Replace the remote control batteries as needed. The remote control requires two AA batteries. When these batteries are low on power, the remote control enters a