Juniper Networks M5, M10 manual Install a PIC Cable

Replace Packet Forwarding Engine Components

3.Unplug the cable from the cable connector port. If the PIC uses fiber-optic cable, immediately cover each transceiver and the end of each cable with a rubber safety cap.

Do not look directly into the ends of fiber-optic cables or into the transceivers on the interface faceplate. Single-mode fiber-optic cable and the interfaces that use it (such as ATM and SONET/SDH interfaces) emit laser light that can damage your eyes.

Do not leave a fiber-optic transceiver uncovered except when inserting or removing cable. The safety cap keeps the port clean and prevents accidental exposure to laser light.

4.Remove the cable from the cable management system and detach it from the destination port.

Install a PIC Cable

To install a PIC cable, follow this procedure (see Figure 32):

1.Have ready a length of the type of cable used by the PIC. For cable specifications, see the M5 and M10 Internet Routers PIC Guide.

2.If the PIC cable connector port is covered by a rubber safety plug, remove the plug.

Do not look directly into the ends of fiber-optic cables or into the transceivers on the interface faceplate. Single-mode fiber-optic cable and the interfaces that use it (such as ATM and SONET/SDH interfaces) emit laser light that can damage your eyes.

Do not leave a fiber-optic transceiver uncovered except when inserting or removing cable. The safety cap keeps the port clean and prevents accidental exposure to laser light.

Replace Hardware Components 93