Juniper Networks M10, M5 manual Remove the Routing Engine, Install the Routing Engine

Replace Routing Engine Components

4.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see “Prevent Electrostatic Discharge Damage” on page 134.

5.Using a Phillips screwdriver, loosen and remove the five screws that secure the Routing Engine cover to the FEB faceplate (the cover is shown in Figure 3). Pull the cover straight off the Routing Engine. Save the screws.

6.Using your thumbs, push and hold the red tab on each extractor clip toward the outer edge of the unit. Push the ends of the extractor clips outward to unseat the Routing Engine from the chassis.

7.Grasp the extractor clips and slide the unit about halfway out of the chassis.

Slide the Routing Engine straight out of the chassis. Damage can result if it gets lodged because of uneven movement.

8.Place one hand under the Routing Engine to support it, slide it completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag.

Figure 42: Remove the Routing Engine

Extractor clip

Install the Routing Engine

To install the Routing Engine, follow this procedure (see Figure 43):

1312

1.Verify that the power switch on both power supply faceplates is in the OFF (O) position.

116M5 and M10 Internet Routers Hardware Guide