Juniper Networks M10, M5 manual Replace Connectors to Routing Engine Interface Ports

Replace Routing Engine Components

Figure 43: Install the Routing Engine

Extractor clip

1313

Replace Connectors to Routing Engine Interface Ports

The ports on the craft interface connect the Routing Engine to external management devices (see Figure 44).

Figure 44: Routing Engine Interface Ports and Alarm Relay Contacts

Lamp test button

Link status LED

Routing Engine ports

Red alarm LED
Yellow alarm LED
Activity status LED
PIC0/3	PIC0/2	PIC0/1	PIC0/0
PIC1/3	PIC1/2	PIC1/1	PIC1/0
		PIC online/offline buttons	1336

To replace the cables that connect to the ports, perform the procedures described in the following sections:

•

•

Replace the Management Ethernet Cable on page 118

Replace the Console or Auxiliary Cable on page 119

Replace the Management Ethernet Cable

To connect the Routing Engine to a network for out-of-band management, connect an Ethernet cable with RJ-45/RJ-45 connectors to the MGMT port on the craft interface. One

118M5 and M10 Internet Routers Hardware Guide