Juniper Networks M10, M5 manual Serial Port Connector

Replace Routing Engine Components

1.If a cable is already installed in the CONSOLE or AUX/MODEM port, perform the following steps:

a.Turn off the power to the console or auxiliary device.

b.Unscrew the screws that secure the cable connector to the port, using a 2.5-mm flat-blade screwdriver if necessary.

c.Pull the cable connector straight out of the port.

d.Disconnect the cable from the console or auxiliary device.

2.Plug the female end of the replacement serial cable into the appropriate CONSOLE or AUX/MODEM port. Figure 44 shows the external device ports on the craft interface.

3.Tighten the screws on the connector, using a 2.5-mm flat-blade screwdriver if necessary.

4.Power on the auxiliary or console device.

Figure 46: Serial Port Connector

1027

120M5 and M10 Internet Routers Hardware Guide