Juniper Networks M5, M10 manual Cable Connector Pinouts, 171, RJ-45 Connector Pinout

Appendix C

Cable Connector Pinouts

This chapter describes the pinouts for the following cable connectors:

•RJ-45 Connector Pinouts for the Routing Engine MGMT Port on page 171

•DB-9 Connector Pinouts for the Routing Engine AUX/MODEM and CONSOLE Ports on page 171

•

•

RJ-48 Cable Pinouts for E1 and T1 PICs on page 172

RJ-21 Cable Pinouts for Fast Ethernet 12-Port PIC on page 175

RJ-45 Connector Pinouts for the Routing Engine MGMT Port

The port on the craft interface labeled MGMT is an autosensing 10/100-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or other device that supports out-of-band management). For more information, see “Routing Engine Interface Ports and Status Indicators” on page 15. Table 19 describes the RJ-45 connector pinout.

Table 19: RJ-45 Connector Pinout

Pin

1

2

3

4

5

6

7

8

Signal

TX+

TX-

RX+

Termination network

Termination network

RX-

Termination network

Termination network

DB-9 Connector Pinouts for the Routing Engine AUX/MODEM and CONSOLE Ports

The ports on the craft interface labeled AUX/MODEM and CONSOLE are DB-9 receptacles that accept RS-232 (EIA-232) cable. The AUX/MODEM port connects the Routing Engine

Cable Connector Pinouts 171