Juniper Networks M5, M10 manual Install the Fan Tray, Remove the Fan Tray

Replace the Fan Tray

4.Place one hand under the fan tray to support it and slide the tray completely out of the chassis after the fans stop spinning.

Figure 26: Remove the Fan Tray

1325

Install the Fan Tray

To install the fan tray, follow this procedure (see Figure 27):

1.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see “Prevent Electrostatic Discharge Damage” on page 134.

2.Grasp the handle on the faceplate of the fan tray with one hand and place the other hand under the unit to support it. Orient the tray so that the handle and thumbscrews fans are on the right side, toward the outer edge of the router.

3.Slide the tray into the slot.

4.Tighten the thumbscrews to seat the fan tray firmly in the chassis.

Replace Hardware Components 83