Juniper Networks M5, M10 manual Routing Policy

Routing Engine Software Components

In the multicast routing table, the routing protocol process uses traffic flow and other parameters specified by the multicast routing protocol algorithms to select active routes.

•MPLS routing table—Stores MPLS label information.

For unicast routes, the routing protocol process determines active routes by choosing the most preferred route, which is the route with the lowest preference value. By default, the route’s preference value is simply a function of how the routing protocol process learned about the route. You can modify the default preference value using routing policy and with software configuration parameters.

For multicast traffic, the routing protocol process determines active routes based on traffic flow and other parameters specified by the multicast routing protocol algorithms. The routing protocol process then installs one or more active routes to each network destination into the Routing Engine’s forwarding table.

You can configure additional routing tables to meet your requirements, as described in the

JUNOS Internet Software Configuration Guide: Routing and Routing Protocols.

Routing Policy

By default, all routing protocols place their routes into the routing table. When advertising routes, the routing protocols, by default, advertise only a limited set of routes from the routing table. Specifically, each routing protocol exports only the active routes that were learned by that protocol. In addition, IGPs (IS-IS, OSPF, and RIP) export the direct (interface) routes for the interfaces on which the protocol is explicitly configured.

For each routing table, you can affect the routes that a protocol places into the table and the routes from the table that the protocol advertises by defining one or more routing policies and then applying them to the specific routing protocol.

Routing policies applied when the routing protocol places routes into the routing table are called import policies because the routes are being imported into the routing table. Policies applied when the routing protocol is advertising routes that are in the routing table are called export policies because the routes are being exported from the routing table. In other words, the terms import and export are used with respect to the routing table.

Routing policy enables you to control (filter) which routes are imported into the routing table and which routes are exported from the routing table. Routing policy also allows you to set the information associated with a route as it is being imported into or exported from the routing table. Routing policies applied to imported routes control the routes used to determine active routes, whereas policies applied to exported routes control which routes a protocol advertises to its neighbors.

You implement routing policy by defining policies. A policy specifies the conditions to use to match a route and the action to perform on the route when a match occurs. For example, when a routing table imports routing information from a routing protocol, a routing policy might modify the route’s preference, mark the route with a color to identify it for later manipulation, or prevent the route from even being installed in a routing table. When a routing table exports routes to a routing protocol, a policy might assign metric values, modify the BGP community information, tag the route with additional information, or prevent the route from being exported altogether. You also can define policies for redistributing the routes learned from one protocol into another protocol.

JUNOS Internet Software Overview 25