Juniper Networks M10, M5 manual Connect to a Network for Out-of-Band Management

Connect the Router to Management Devices

Figure 21: Routing Engine Management Ports

Lamp test button

Link status LED

Routing Engine ports

Red alarm LED
Yellow alarm LED
Activity status LED
PIC0/3	PIC0/2	PIC0/1	PIC0/0
PIC1/3	PIC1/2	PIC1/1	PIC1/0
		PIC online/offline buttons	1336

To connect external devices to the Routing Engine management ports, perform the procedures described in the following sections:

•

•

Connect to a Network for Out-of-Band Management on page 62

Connect to a Management Console or Auxiliary Device on page 63

Connect to a Network for Out-of-Band Management

To connect the Routing Engine to a network for out-of-band management, connect an Ethernet cable with RJ-45/RJ-45 connectors to the MGMT port on the craft interface. One such cable is provided with the router. For cable specifications, see “Cable Specifications for Routing Engine Management Interfaces” on page 52. Follow this procedure:

1.Turn off the power to the management device.

2.Plug one end of the Ethernet cable (Figure 22 shows the connector) into the MGMT port on the craft interface (see Figure 21).

3.Plug the other end of the cable into the network device.

62M5 and M10 Internet Routers Hardware Guide