Juniper Networks M10, M5 manual Craft Interface

Craft Interface

For specific information about Routing Engine components (for example, the capacity of the hard drive), issue the show chassis routing-enginecommand.

Figure 6: Routing Engine
Routing Engine 333	Routing Engine 600
Extractor clip	Extractor clip

		PC
		CA
		RD
		RESET
LED		HD
PC card slot		PC card slot
	Extractor clip	LED

Extractor clip

1596

Craft Interface

The craft interface provides status and troubleshooting information at a glance and has buttons for deactivating alarms and preparing FPCs for removal. The L-shaped craft interface is located along the left and bottom edges of the front of the chassis, as shown in Figure 1 and Figure 2. It includes the elements shown in Figure 7. (The LEDs for the power supplies are located on the power supply faceplate, rather than on the craft interface. For more information, see “Power Supply LEDs and Self-test Button” on page 19.)

Figure 7: Craft Interface

Lamp test button

Link status LED

Routing Engine ports

Red alarm LED
Yellow alarm LED
Activity status LED
PIC0/3	PIC0/2	PIC0/1	PIC0/0
PIC1/3	PIC1/2	PIC1/1	PIC1/0
		PIC online/offline buttons	1336

14M5 and M10 Internet Routers Hardware Guide