Juniper Networks M10, M5 manual Pack the Router for Shipment

Pack the Router for Shipment

Figure 54: Routing Engine 600 Serial Number ID Label

1576

*1 2 3 4 5 6 7 8 9 1 0 1 2 *

Serial number ID label

Pack the Router for Shipment

To pack the router for shipment, follow this procedure:

1.Retrieve the shipping box and packing materials in which the router was originally shipped.

2.On the console or other management device connected to the Routing Engine, enter CLI operational mode and issue the following command to shut down the router software cleanly and preserve Routing Engine state information.

user@host> request system halt

Wait until a message appears on the console confirming that the operating system has halted.

For more information about the command, see the JUNOS Internet Software Operational

Mode Command Reference: Protocols, Class of Service, Chassis, and Management.

3.Shut down power to the router by pressing the power switch for both power supplies to the OFF (O) position. On both AC and DC power supplies, the switch is located on the power supply faceplate.

4.Disconnect power from the router. For instructions, see “Disconnect AC Power from the Router” on page 102 or “Disconnect DC Power from the Router” on page 109.

5.Remove the cables that connect to all PICs and external devices. For instructions, see “Replace Connectors to Routing Engine Interface Ports” on page 118 and “Remove a PIC” on page 87.

168M5 and M10 Internet Routers Hardware Guide