Juniper Networks M10, M5 manual Replace Packet Forwarding Engine Components

Replace Packet Forwarding Engine Components

3.Insert the cable connector into the cable connector port on the PIC faceplate.

4.Arrange the cable in the cable management system to prevent it from dislodging or developing stress points. Secure the cable so that it is not supporting its own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop in the cable management system. Placing fasteners on the loop helps to maintain its shape.

Avoid bending fiber-optic cable beyond its minimum bend radius. An arc smaller than a few inches in diameter can damage the cable and cause problems that are difficult to diagnose.

Do not let fiber-optic cable hang free from the connector. Do not allow fastened loops of cable to dangle, which stresses the cable at the fastening point.

5.Insert the other end of the cable into the destination port.

6.Repeat the previous steps for any additional cables.

7.If the PIC is offline (its failure indicator LED is lit), use one of the following methods to bring the PIC online:

•Press and hold the PIC offline button until the status LED on the PIC faceplate indicates normal functioning, which usually takes about 5 seconds. The LED is usually green; for more information, see the M5 and M10 Internet Routers PIC Guide. The offline button for each PIC is located below it on the craft interface and

is labeled with the PIC slot number.

•Issue the following CLI command:

user@host>request chassis pic fpc-slot fpc-slotpic-slot pic-slotonline

For more information about the command, see the JUNOS Internet Software

Operational Mode Command Reference: Protocols, Class of Service, Chassis, and

Management.

The normal functioning indicator LED confirms that the PIC is online. You can also verify correct PIC functioning by issuing the show chassis fpc pic-statuscommand described in “Maintain PICs and PIC Cables” on page 76.

94M5 and M10 Internet Routers Hardware Guide