JVC BD-X200E manual RS-422A Remote terminal D-sub 9-pin male, LAN terminal RJ-45, USB terminals

$
	VIDEO		AUDIO
	IN LINE OUT	INPUT	CH1
		LEVEL	IN	OUT
			4dB
			8dB
	Y/C
	IN
			CH2
	DV IN/OUT		REMOTE
				8
LAN	SIGNAL	USB	DC 19V
	GND
				!
9 #		0	@

English

8RS-422A REMOTE terminal (D-sub 9-pin male)

This terminal is used to connect the DVD recorder to a VCR capable of being controlled via RS-422A.

●Select the control method of this terminal with the REMOTE SELECT item on the REMOTE MENU screen. 9PIN(MASTER): This machine controls the VCR as

	master.
9PIN(PLAY):	Use this setting to use this machine as a
	player.
9PIN(REC):	This machine is a slave operated in
	accordance with instructions from a non-
	linear editor.

9LAN terminal (RJ-45)

●When two DVD recorders are used to perform DVD-to-DVD dubbing, this terminal is connected to both BD-X200s. A cable of Category 5 or better is required for this connection. A cross-type Ethernet cable is required when connecting directly to another BD-X200.

●This terminal is also used when connecting to a PC on which BD-X200 utility software for operations such as the creation of the title and chapter menus has been installed.

●Network settings must be carried out using the NETWORK MENU screen.

0USB terminals (2)

These terminals are used when connecting the DVD recorder to USB devices such as a keyboard or mouse.

A keyboard and mouse can be used as an alternative to the DVD recorder’s buttons when using setting and control screens.

The input of text in setting screens is carried out using a keyboard.

●It is not be possible to operate devices other than a keyboard or mouse by connecting them to the USB terminal.

●Set KEYBOARD STYLE from the SYSTEM MENU screen

in accordance with the keyboard’s input language. Recommended manufacturers: Logitech

!DC IN terminal (2-pin)

This terminal is used to provide DC at 19 V to the DVD recorder. The DC power cord from the AC adaptor (included) should be connected here.

Note

When power is supplied via this terminal, the OPERATE indicator on the front panel lights up in red.

@DC power cord clamp

This clamp secures the DC power cord in place, and it should always be used to prevent accidental disconnection.

#SIGNAL GND terminal

This terminal is used to ground signals.

$Optional-board slot cover

This cover is removed to allow commercially-available optional boards to be installed.

E-13