JVC BD-X200E manual Playback, Playing Back a Finalized Disc

Playback

Playing Back a Finalized Disc

This DVD recorder can also be used to playback discs that it has recorded and finalized. When a disc is finalized, its title menu will be used to create the top menu.

The action taken by your BD-X200 when a disc it has finalized is inserted or when playback of a title has ended will depend on the settings of DISC IN ACTION and TITLE END as set on the RECORDER MENU (2/2) screen during recording.

*Playback may not proceed smoothly with discs recorded using different devices, regardless of whether or not they have been finalized.

Caution

●During playback of a disc, if the input setting is DV then the sound can be delayed. In this case, change the input setting to LINE or Y/ C.

●If the disc is dirty or damaged good playback may not be possible. In this case either clean the disc or change it.

			BUSY
OPERATE			OPEN/CLOSE
	DVD RECORDER BD-X200		OPTION DV Y/C LINE
			SET UP
AUDIO	TITLE	CHAPTER

CH1	DOLBY DIGITAL
	LPCMMPEG

CH2

	MENU MENU	SET	Cursor buttons
PHONES	REV STOP PLAY FWD PAUSE REC TOP

(t, 8, 7, and 6)

STOP button PAUSE button SET button

PLAY button

1.Insert a disc.

Depending upon the INTRODUCTION TITLE item and the DISC IN ACTION item settings of the RECORDER MENU (2/2) screen during recording, the operation will differ. Operate in accordance with the table below. (For the operation with a disc with a DVD MENU TYPE item set to NONE, refer to page 61.)

INTRODUCTION TITLE item setting during recording

Set to OFF	Set to ON
The action set in the DISC IN ACTION item is carried out.	The introduction title (opening movie) is automatically played.
(See below.)	After playback is finished, the action set in the DISC IN ACTION
	item is carried out. (See below.)
DISC IN ACTION setting made during recording
MENU	TITLE
The title menu will appear	Playback starts automatically from the first title.

2.Select the number of the title to be played.

Use the t, 8, 7, and 6 buttons to select the title number for playback.

3.Press the SET button to begin playback.

4.Set to Still mode.

This is done by pressing the PAUSE button.

●The DVD recorder enters Still mode.

●If the PAUSE button is then pressed again in Still mode, the DVD recorder will advance playback by a single frame.

5.Restart playback.

Press the PLAY button.

The DVD recorder will behave as follows when title playback has ended.

These actions will depend on the setting made for TITLE END from the RECORDER MENU (2/2) screen during recording.

TITLE END item setting during recording

Set to MENU	Set to REPEAT	Set to STOP	Set to NEXT TITLE
Enters stop mode and the	Repeats playback within	Enters the stop mode. The	Next title is played. When playback
title menu (TOP MENU) is	the title.	title menu (TOP MENU) is	of the final title finished, the first title
displayed.		not displayed.	is played. (Disc repeat playback)

6.Stop playback.

This is done by pressing the STOP button. ● The DVD recorder enters Stop mode.

Note

When the introduction title (opening movie) is played on another DVD player only the STOP button is accepted.

E-60