JVC DR-M100S manual Plug & Play Set, Auto Clock Set/Auto Tuner Set, Information

		INITIAL SETTINGS EN 17
	Plug & Play Set	1 Connect the antenna cable to the unit. (A pg. 16) Then connect
		the AC power cord to an AC outlet. Do not turn on the unit. The
		clock and tuner channels will be set automatically.
Auto Clock Set/Auto Tuner Set
		● ALOADINGB blinks on the front display panel when the AC plug
		of the power cord is connected into an AC outlet and it takes
This unit sets the clock and tuner channels automatically when AC		approximately 30 seconds for the unit to be turned on. This is
power cord is first connected to an AC outlet. The antenna cable		not a malfunction.
must be connected for the Plug & Play setting.		NOTES:
The time and date are set automatically by the clock setting data		● Auto Clock Set is performed first. AAUTOB blinks on the front
transmitted from one of the regular TV broadcast channels. We call
		display panel during Auto Clock Set.
this TV channel the “host channel” and it is a PBS channel in your
		● Auto Channel Set is performed next. Auto Channel Set scans all
area.
		the channels that are receivable by your unit. During Auto
ATTENTION:		Channel Set, the channel numbers are displayed as they are
Depending on areas or reception conditions, the unit may not		scanned and set.
		● When Plug & Play setting has been completed successfully, the
receive the Auto clock setting data from the PBS channel. If this
		correct clock time is displayed. If you perform Plug & Play setting
function is taking a considerable amount of time, it may be
		successfully, there is no need to perform ACLOCK SETB
necessary to perform the Semiauto or Manual Clock Set
		(A pg. 19) and ATUNER SETB (A pg. 20). If, however, you want
procedure.
		to add or delete channels, refer to AMANUAL CH SETB
		(A pg. 20).
		During Auto Clock Set
		AAUTOB blinks.

CH+

STANDBY/ON

PUSH-OPEN

CH-

During Auto Channel Set

The channel numbers are displayed and AAUTOB blinks as they are scanned and set.

INFORMATION

●If AAUTO CLOCKB is set to AONB (A pg. 19) the clock will be adjusted automatically by the host channel using the incoming PBS channel clock setting data. (This automatic clock adjustment can only be performed when the unit is turned off.)

●If the memory backup fails, because a power outage occurs or because the AC power cord is unplugged, Plug & Play will be performed when power is restored to the unit.

What to do if Plug & Play setting failed

●If an incorrect time is displayed on the front display panel, you may be receiving the clock setting data of a PBS channel from an adjacent time zone, or an incorrect PBS channel from a cable TV system. In this case, perform “Semiauto Clock Set” (A pg. 19) or “Manual Clock Set” (A pg. 19).

●If A- - : - -Bappears on the front display panel, your antenna cable may not be connected to the unit or there may not be a Host PBS signal available in your area. Ensure that the antenna cable is connected correctly. Then turn on and off the unit; the Plug & Play setting will be automatically reactivated. If Plug & Play setting is not performed though the antenna cable is connected correctly, perform “Manual Clock Set” (A pg. 19) and “Auto Channel Set” (A pg. 20) or “Manual Channel Set” (A pg. 20).

Plug & Play Completed

The current time is displayed.

●If an incorrect clock time or A- - : - -Bappears on the front display panel, see “What to do if Plug & Play setting failed” on the left column.