Power Switch
To DV OUT
Core filter
DV cable (optional)
To DV IN
Video unit equipped with DV connector
PLAY (4)
STOP (5)
EN39
Digital Dubbing
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
1 Make sure the camcorder’s power is off.
2 Connect the camcorder to your video unit equipped with a DV connector using a DV cable as shown in the illustration.
3 Press 4to play back the source tape.
4 While watching the playback on the monitor, engage the DV
NOTES:
●It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack (☞ pg. 7).
●When using the camcorder for dubbing, be sure to use it as a player. The camcorder's DV connector is only for output.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 3. If this occurs, turn off the power and make connections again.
●If “Playback Zoom” (☞ pg. 42), “Playback Special Effects” (☞ pg. 43) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV OUT connector.
●When using the cables, make sure you connect the end
of the cable with the core filter to the camcorder. The core filter reduces interference (☞ pg. 5).
