JVC GV-DS2 EN Advan CED Oper Ations, Changing ID number, Connecting other device during operation

64EN ADVANCED OPERATIONS

Changing ID number

The device's ID number is preset at factory as follows:

ex. Camcorder: 06 or 07 Video printer: 20

When connecting more than two same type devices, the same ID numbers will exist and a malfunction can occur. To avoid a malfunction, change the ID numbers.

It is recommended to change the ID number of an already connected device before connect- ing the same type device.

1 ACCESSBOX "ID CHANGE" DIALOG

Choose "ID Change" from "Set-up" on the JLIP VIDEO PRODUCER window.

•The "ID Change" dialog box appears.

2 SELECT DEVICE

Click on the name of the device and "CHANGE".

•The dialog box to enter new ID number appears.

3 ENTER NEW ID NUMBER

4 SET ID NUMBER

Click "OK".

•The message "The device ID will be changed." appears.

Clicking "OK" again sets that ID number and brings up the JLIP VIDEO PRODUCER window.

NOTES:

●After step 4, perform the following ‘Connecting other device during operation’.

●Do not enter ID number "0" because "JLIP Video Producer software" does not recognize "ID 0".

ID Change

Select the device to change.

VCR

06:VCRCAMERA CHANGE CLOSE

VIDEO PRINTER

CHANGE

ID Change

Enter a number between 1 and 99.

ID = 06

OK CANCEL

Connecting other device during operation

When connecting an other device during operation or changing ID numbers, initializing is necessary to confirm the connected devices. (Not necessary to run "JLIP Video Producer software" from beginning again.)

1 INITIALIZE

Choose "Initialize" from "Set-up" on the JLIP VIDEO PRODUCER window.