TONE FREQ. ID

This function scans through all tone frequencies to identify the incoming tone frequency on a received signal. You may use the function to find which tone frequency is required by your local repeater.

1Press [F], [2] (1 s) to activate the function.

• The Tone function is switched ON.

STA CON PACKET96 BCONDUP

5 7 9

•If you access “F–2 (TONE FREQ)” using [UP]/ [DWN] in Function Select mode, press [OK] (1 s) to activate the function.

•To reverse scan direction, press [UP] (upward scan) or [DWN] (downward scan).

•To quit the function, press [ESC].

•When the tone frequency is identified, the identified frequency appears and blinks.

2Press [OK] to program the identified frequency in place of the currently set tone frequency.

•The previous frequency display is restored with the Tone function remained ON. You may press [F], [1] to switch the Tone function OFF.

•Press [ESC] if you do not want to program the identified frequency.

•Press [UP]/ [DWN] while the identified frequency is blinking, to resume scanning.

Downloaded by

RadioAmateur.EU

 

 

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

25