APPENDIX
TNC COMMANDS LISTThe commands supported by the
Command Name | Short | Default | Parameter | Description | |
|
|
|
|
| |
AUTOLF | AU | ON | ON/ OFF | When ON, sends a line feed (LF) to the computer after each | |
carriage return (CR). | |||||
|
|
|
| ||
|
|
| EVERY/ | If set to EVERY, sends a beacon packet at intervals of the | |
|
|
| specified period (n). If set to AFTER, sends a beacon packet | ||
BEACON | B | EVERY 0 | AFTER n | ||
only once after the specified period (n). The unit of n is | |||||
|
|
| (n = 0 ~ 250) | ||
|
|
| 10 seconds. | ||
BTEXT | BT | — | 0 ~ 159 | Specifies the content of the data portion of a beacon packet. | |
characters | |||||
|
|
|
| ||
CALIBRAT | CAL | — | — | Sends a space/mark square wave (50/50 ratio). Enter Q to | |
exit Calibrate mode and restore the Command mode. | |||||
|
|
|
| ||
CHECK | CH | 30 | 0 ~ 250 | Specifies the interval from signal | |
disconnection. The unit of the parameter is 10 seconds. | |||||
|
|
|
| ||
|
|
| Call1 (VIA | Sends a connect request. Call1 is the call sign of the station | |
CONNECT | C | — | call2, call3, ... | to be connected to. Call2 to call9 are call signs of stations to | |
|
|
| call9) | be digipeated through. | |
CONVERSE | CONV | — | — | Causes the TNC to enter Converse mode. Press [Ctrl]+[C] to | |
or K | restore the Command mode. | ||||
|
|
| |||
CPACTIME | CP | OFF | ON/ OFF | When ON and in Converse mode, sends a packet at intervals | |
of the period determined by PACTIME. | |||||
|
|
|
| ||
CR | CR | ON | ON/ OFF | When ON, appends a carriage return (CR) to all packets to be | |
sent. | |||||
|
|
|
| ||
DISCONNE | D | — | — | Sends a disconnect request. | |
|
|
|
|
|
99