4-12
f) Pull straight up and disconnect the three
wire connectors from the motor termi-
nals.
g) Lift the locking arm, and rotate the
locking ring in a counterclockwise di-
rection until the outer tabs line up with
the tub slots. NOTE: The motor hous-
ing tabs and slots will also be loose at
this point.
h) Lift the motor housing, locking ring, and
heater element off the tub, and pull the
suction nozzle out of the tub drain opening.
Locking Arm
Align These
Tabs and Slots
Motor Housing
i) Remove the wash and drain motor and
the heater element from the tub.
3 Motor Wire
Connectors
Suction Nozzle
Drain Opening
REASSEMBLY NOTES:
1. Check the motor and heater seals for wear
or damage. Replace them, if necessary.
2. When you reinstall the heater element,
locking ring, and wash & drain motor onto
the tub, make sure that the seals below the
locking ring and the motor housing are
properly positioned to prevent leaking.
3. When tightening the locking ring, make
sure that you tighten it fully so that the
locking arm (shown in the photo to the left)
is locked behind the tub. If the ring is not
fully tightened, the locking tabs will not
align properly with the slots in the wiring
cover.
Motor W/Seal
Installed Heater Element