8.To remove the hall sensor:
a)Disconnect the wire connector at P701.
b)Unclip the locking tab from the hall sensor board and lift the board up and off the motor/heater housing.
Locking Tab
Hall Sensor
P701
Wire Connector
Ground Wire
Drain & Fill
Hoses
Heater Locking Ring
Electrical | Element | |
Connector | ||
Wires | ||
|
Lift Sensor
9.To remove the wash and drain motor and heater element assembly:
a)Remove the hall sensor (see step 8).
b)Disconnect the green wire from the ground terminal (see the photo at the top of the right column).
c)Remove the drain and fill hoses, and the electrical wires from the locking ring clips.
d)Disconnect the heater element wiring connector.
e)Unclip the two locking arms on the motor housing from the end of the drain hose, and pull the hose out of the housing.
Drain Hose
Motor Housing
W / Locking Arms
