FILL FAILURE
Water Supply Valve Turned Off
Turn on water supply valve.
Inlet Valve Failed
1.Unplug dishwasher or disconnect power.
2.Check resistance of inlet valve coil, replace if necessary.
Low Water Pressure
Water pressure must be above 4.3 psi.
Spray Arm Not In Place
Put spray arm back in proper location.
Obstructed Inlet Hose Or Inlet Valve
Clear obstructions.
Bad Wiring Or Connections
1.Unplug dishwasher or disconnect power.
2.Check wiring and connectors to controller.
Machine Is Siphoning
Check drain hose installation.
Impeller Is Slipping On Rotor
Replace rotor and impeller assembly.
ELECTRONICS FAILURE (EEPROM Access Error)
Dishwasher Will Not Operate
1.Unplug dishwasher or disconnect power for 10 seconds.
2.Plug in dishwasher or reconnect power. Error code should clear.
3.If error code remains, replace electronic controller.
WATER TEMPERATURE SENSED GREATER THAN 185°F (85°C)
Inlet Water Above 185°F (85°C)
Adjust water heater setting.
Heater Element On Continuously
1.Unplug dishwasher or disconnect power.
2.Replace electronic controller.
Moisture Around Temperature Sensor
1.Unplug dishwasher or disconnect power.
2.Repair any water leaks from tub.
Wiring Or Connections Bad
1.Unplug dishwasher or disconnect power.
2.Check all wiring and connections from elec- tronic controller to element.
Temperature Sensor Failed
1.Unplug dishwasher or disconnect power.
2.Check resistance of temperature sensor; replace heater plate, if necessary.
