REMOVING THE RINSE AID AND
DETERGENT DISPENSER
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Unplug dishwasher or disconnect power.
2.Turn off the water going to the dishwasher.
3.Disconnect the drain line from the dish- washer.
4.Remove the door panel from the drawer (see page
5.Remove the dishwasher drawer and turn it over (see page
8.Disconnect the wire connectors from the rinse aid and detergent dispenser. Press out on the locking tab of each connector to release the connectors.
9.Remove the three T10 torx screws from the left and right housing mounting brack- ets, and remove the brackets.
10.Lower the rinse aid and detergent dispenser housing assembly into the tub and remove it.
Left Bracket & Screws
Dispenser Hose Clamp
Rinse Aid & Detergent Dispenser
6.Remove the rinse aid LED from the rinse aid and detergent dispenser housing (see page
7.Loosen the clamp on the dispenser hose, and slide the clamp off the dispenser fitting, (see the photo in step 10), then pull the dispenser hose off the fitting.
Wire Connector
Locking Tab
11.Check the seal around the dispenser to make sure that it is not damaged or worn.
Seal
