4.Feed the wires of the medallion through the front of the custom front panel and push the medallion into the prepared me- dallion hole.
5.Lay the custom front panel face down on a protective covering.
6.Remove the pin on both sides of the dish- washer drawer with a pair of needlenose pliers. Pull the pin straight out.
pin
7.Gently pull the bottom of the metal plate away from the dishwasher, and then pull down.
10.Align the centerline marked on the custom panel with the diamond shape and notch in the metal plate to center the metal plate horizontally. Align the horizontal line with the top of the metal plate.
horizontal line
top of plate
centerline
11.Fasten the metal plate with the three inner holes on the outside of the bracket on each side to the front panel with screws provided.
three inner holes
8.Lay the custom front panel face down.
9.Feed the medallion wires through the wire opening in the metal plate. Lay the metal plate on the back of the custom front panel.
wire opening
metal plate
front panel
12.Connect the medallion connector to the dishwasher connector.
13.Fit the metal plate tabs to the notches and slots on the dishwasher and gently pull up to lock in place.
