KitchenAid KAD-9 manual General, Tools and Material Required, Parts Supplied

INSTALLATION INFORMATION

GENERAL

IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock.

Proper installation is your responsibility:

•Contact a qualified installer to insure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances.

•Install the dishwasher as specified in these instructions.

•Have everything you need to properly install dishwasher.

•Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty.

•This dishwasher is manufactured for inside use only.

•Install and level dishwasher on floor that will hold the weight, and in an area suitable for its size and use.

TOOLS AND MATERIAL REQUIRED

Assemble the required tools and parts before starting installation. Read and follow the in- structions provided with any tools listed here.

•utility (carton) knife

•pliers

•tape measure

•flat-bladed screwdriver

•#2 phillips screwdriver

•side cutting pliers

•pencil

•sandpaper

•level

•wood cutting board

•adjustable wrench that opens to 1-1/8″(29 mm)

•7 mm socket wrench

•5 mm socket wrench

•5 mm open end or box end wrench

•electric or hand drill

•1-1/2″hole saw

•valve (sized to fit hot water supply line) with 3/8″ male compression fitting

•protective floor covering

PARTS SUPPLIED

Located in bottom drawer:

•2 flexible extrusions (for sides)

•1 flexible extrusion (for top)

•edge protection

•hose clamp, hose-type

•washer

•2 installation brackets (top)

•drain hose support

•drain hose connector

•2 hose clamps, wire-type

•24 #8 phillips wood screws

•toe kick

•custom toe kick mounting bracket

•moisture protection tape

2-1