NOTE: The drain hose connector must not support the weight of excess hose length. Keep the hoses as fully extended as possible.

For standpipe installations:

IMPORTANT: To prevent siphoning, the hoses should not extend further than 4-3/4(12.1 cm) down the standpipe.

4-3/4" (12.1 cm)

diameter of standpipe must be large enough to create air gap

7.Install the flat seal washer on the end of the inlet hose. Connect the inlet hose to the water supply valve. Tighten securely.

Turn the water valve on and check for leaks.

valve

flat seal washer

inlet hose

8.Open the top drawer. Remove the packing tape from the front and rear of the dish rack.

Close the drawer.

Open the bottom drawer. Remove the packing tape from the front and rear of the dish rack.

Close the drawer.

Other Plumbing Options

1/4"-32–

cm)82–

 

waste

 

 

 

27-1/2"

(70 cm

 

valve

 

water supply

 

 

 

 

 

 

waste

 

 

 

8" (20.3 cm) min. bend

 

 

 

radius from valve

 

 

Option 1

 

1-1/2" (3.8 cm) Standpipe With Air Gap

 

 

 

6" (15.2 cm)

 

 

 

minimum

-1/4"

cm)

 

garbage

 

disposal

– 32

– 82

valve

 

27-1/2"

(70 cm

waste

 

water supply

 

 

 

 

 

 

8" (20.3 cm) min. bend

 

 

 

radius from valve

Option 2

Garbage Disposal

air break

drain hose connector

waste

valve

water supply

8" (20.3 cm) min. bend radius from valve

Option 3

Air Break With Drain Hose Connector

2-13

Page 23
Image 23
KitchenAid KAD-9 manual For standpipe installations, Other Plumbing Options