KitchenAid KAD-9 manual Removing the Drying FAN and Rinse AID LED

REMOVING THE DRYING FAN AND RINSE AID LED

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Unplug dishwasher or disconnect power.

2.Turn off the water going to the dishwasher.

3.Disconnect the drain line from the dish- washer.

4.Remove the door panel from the drawer (see page 4-4 for the procedure).

5.Remove the dishwasher drawer and turn it over (see page 4-9 for the procedure).

6.Pull out on the drying fan air chute and slide the chute off the drawer. NOTE: The top of the chute has two small slots that fit into tabs, so you may have to push up on the top while you pull out to clear the tabs.

7.Pull the fan/LED connector off the control- ler board marked FAN.

Fan/LED

Connector

Air Chute

8.Using a straight-blade screwdriver, pry the three locking tabs holding the drying fan away from the fan, and remove it from the drawer holder.

Locking Tabs

Rinse Aid LED Drying Fan

NOTE: The drying fan and rinse aid LED are replaced as an assembly.

Continued on the next page.

4-5