7Changing Settings | Kohler 48VDC, 6VSG, 24VDC, 36VDC specification

Changing Date/Time

1. Press the Select button to enter the main menu.				8.	When the correct date is shown, press the Select
					button. The saved date is shown.
Press:	Display:	Overview ---->
Press:	Display:	1.2 h		Press:		Display:	Date:
		1.2 h
							03Jan2012
							03Jan2012
2. Press the down arrow button until the desired
menu is displayed. See Figure 3-9. Date and Time				9.	Press the down arrow button to step to the next
are used for this example.					menu.
		Date	---->	Press:		Display:	Time:
Press:	Display:	Date	---->	Press:		Display:	01:49pm
Press:	Display:	and Time					01:49pm
		and Time
				10.	Repeat steps 5 and 6, using the arrow and select
3. Press the Select button to enter the Date and Time					buttons to set and save the time.
menu.				Note: To change from am to pm, press the up arrow
				Note: To change from am to pm, press the up arrow
Press:	Display:	Date:			key to increase the hour until the correct hour
Press:	Display:	05Dec2011			and pm is displayed.
				11.	In the time format menu, press Select and then
					press the up or down arrow button to change the
4. To change the date and time settings, press the					format, 12 hr. or 24 hr. Press Select to save the
Select button again. The year will flash.					displayed format.
		Date:		12.	Press the	down arrow button. Return is
Press:	Display:	Date:			displayed.
Press:	Display:	05Dec2011			displayed.
		05Dec2011
				Press:		Display:	<---- Return
				Press:		Display:

5.Press the up or down arrow buttons to change the year.

			13. Press Select to return to the Date and Time
			menu.
		Date:
Press:	OR	Display:		Date ---->
Press:	OR	05Dec2012
		05Dec2012	Press:
			Press:	Display:
				and Time
6. When the correct year is shown, press the Select			14. Press the Up or Down arrow buttons to step to a
6. When the correct year is shown, press the Select			different menu.
button. The year is saved and the next setting			different menu.
button. The year is saved and the next setting
(month) flashes.			15. Press Auto to signal the controller to exit the
			15. Press Auto to signal the controller to exit the
		Date:	menus and return to the generator set status
Press:		Date:	display.
Press:		Display:
		05Dec2012
				Genset State
			Press:	Display:
				Standby
7. Repeat steps 5 and 6, using the arrow and select				AUTO
buttons to set the month and the date.			Note: If no buttons are pressed, the controller returns
			Note: If no buttons are pressed, the controller returns
				to the status display after 5 minutes.

Figure 3-7Changing Settings

TP-6843 1/13

Section 3 VSC Controller Operation 27