PULSE WAVE SHAPING PRINCIPLES | Appendix A |
5. Adjust the Start Control Parameters (Optional)
The start control parameters can be adjusted to define how the welding machine will respond when the arc is struck.
To view the start control window, click on the 
button on the Waveform Editor screen. Adjust the start control parameters to accommodate your welding application and per the following parameter descriptions.
STRIKE
STRIKE
PEAK TIME
Start Control - Pulse 
Start Control
For Wire Feed Speed 150
Stage 1 : Wire Run In
Open Circuit Volt 48.0
PEAK AMPS
OPEN
CIRCUIT
START TIME 
VOLTS
ARC
STRIKE
AVERAGE
START
AMPS 
@
START
VOLTS
Stage 2 : Striking Pulse
Strike Peak Time | 2.0 |
Strike Peak Amps | 550.0 |
Stage 3 : Arc Length Control | |
Start Volt | 28.0 |
Start Time | 50 |
Stage 4 : Current Control
Start Amps 50
27850035
Open circuit voltage: Sets the power source output voltage for the torch idle condition (the welding machine is on, but not welding).
Strike peak amps: Adjust this parameter to set the peak level for the
Strike peak time: Adjust this parameter to set the duration of peak current for the
Starting volts: Adjust this parameter to set the gun voltage to be maintained during the arc starting routine.
Starting time: Adjust this parameter to set the duration of the arc starting routine.
Starting amps: Adjust this parameter to set the average current level during starting.
WAVE DESIGNER
