IPoA
If you are required to use IPoA (IP over ATM), then select IPoA.
VC Settings. You will configure your Virtual Circuit (VC) settings in this section.
•Multiplexing. Select LLC or VC, depending on your ISP.
•QoS Type. Select from the
•Pcr (Peak Cell Rate) Rate. If required by your service provider, divide the DSL line rate by 424 to get the maximum rate at which the sender can send cells. Enter the rate in this field.
•Scr (Sustain Cell Rate) Rate. The average cell rate that can be transmitted, this value is normally less than the PCR value. Enter the rate in the field (if required by your service provider).
•Autodetect: Select Enable to have the settings automatically entered, or select Disable to enter the values manually.
•Virtual Circuit. These fields consist of two items: VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier). Your ISP will provide the correct settings for these fields.
•DSL Modulation. Select from the
IP Settings. Follow the instructions in the section for your type of encapsulation.
•IP Address. This is the Gateway’s IP address, when seen from the Internet. Your ISP will provide you with the IP Address you need to specify here.
•Subnet Mask. This is the Gateway’s Subnet Mask. Your ISP will provide you with the Subnet Mask.
•Default Gateway. Your ISP will provide you with the Default Gateway Address, which is the ISP server’s IP address.
•Primary DNS. (Required) and Secondary DNS (Optional). Your ISP will provide you with at least one DNS (Domain Name System) Server IP Address.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes.
Chapter 4: Configuring the Gateway
Figure 4-5: Basic Setup Tab - IPoA
18
The Setup Tab
