Wireless-G ADSL Gateway with 2 Phone Ports
•Hop Count. Hop Count is the number of hops to each node until the destination is reached (16 hops maximum). Enter the Hop Count in the field.
•Show Routing Table. Click the Show Routing Table button to open a screen displaying how data is routed through your network. For each route, the Destination IP address, Subnet Mask, Gateway, and Interface are displayed. Click the Refresh button to update the information. Click the Close button to return to the previous screen.
PVC Routing Policy. PVC stands for "Permanent Virtual Circuit". It is a virtual circuit link between two nodes for ATM (Asynchronous Transfer Mode) network. Each PVC functions as a separate Internet connection. PVC settings are for ADVANCED USERS ONLY. The PVC routing table allows you to select which traffic type to be forwarded to which PVC. Click the PVC Routing Setting button to open the PVC Routing table.
•Please select active connection. Select your active Internet connection from this
•Destination. Enter the destination Internet IP Address and Network Mask where this PVC will send data.
•Source. Enter the source IP Address and Network Mask where this PVC will originate.
•Source Mac. Enter the source MAC Address of the network PC where the data originates.
•Protocol. Enter the data’s protocol, either TCP,UDP or ALL.
•Dst Port. Enter the destination port number where this PVC will send data.
•Src Port. Enter the source port number where this PVC will originate.
•802.1D User Priority. This uses the 802.1D header requirement to set prioritization. The number range is 0~7 depending on the type of services, with 7 having the highest priority.
•802.3 Type/Length. Enter the Ethernet type for a specific protocol.
•802.1Q Vlan ID. This is the ID for VLANs, from 0 ~ 4095
•PacketLength. This is the total packet length of an IP packet, from 20byte~65535bytes.
•DSCP. Enter the TOS (Type of Service) in the IP header here. Possible values are 0x00 to 0x3f, the last two Hex values are the variables.
•Apply. Check this and click the Save button to apply your changes
When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes.
Chapter 4: Configuring the Gateway
Figure 4-14: Routing Table
Figure 4-15: PVC Selection Table
27
The Setup Tab
