![](/images/new-backgrounds/1299179/29917955x1.webp)
RFC 2516 PPPoE
VC Settings. You will configure your Virtual Circuit (VC) settings in this section.
•Multiplexing. Select LLC or VC, depending on your ISP.
•QoS Type. Select from the
•Pcr (Peak Cell Rate) Rate. If required by your service provider, divide the DSL line rate by 424 to get the maximum rate at which the sender can send cells. Enter the rate in this field.
•Scr (Sustain Cell Rate) Rate. The average cell rate that can be transmitted, this value is normally less than the PCR value. Enter the rate in the field (if required by your service provider).
•Autodetect: Select Enable to have the settings automatically entered, or select Disable to enter the values manually.
•Virtual Circuit. These fields consist of two items: VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier). Your ISP will provide the correct settings for these fields.
•DSL Modulation. Select from the
Chapter 4: Configuring the Gateway
Figure 4-6: Basic Setup Tab - RFC 2516 PPPoE
19
The Setup Tab