Linksys WAG54GP2 manual Basic Setup Tab Bridged Mode Only

Wireless-G ADSL Gateway with 2 Phone Ports

Bridged Mode Only

If you are using your Gateway as a bridge, which makes the Gateway act like a standalone modem, select Bridged Mode Only. All NAT and routing is disabled in this mode.

VC Settings. You will configure your Virtual Circuit (VC) settings in this section.

•Multiplexing. Select LLC or VC, depending on your ISP.

•QoS Type. Select from the drop-down menu: CBR (Continuous Bit Rate) to specify fixed bandwidth for voice or data traffic; UBR (Unspecific Bit Rate) for application that are not time sensitive, such as e-mail; or VBR (Variable Bite Rate) for Bursty traffic and bandwidth-sharing with other applications.

•Pcr (Peak Cell Rate) Rate. If required by your service provider, divide the DSL line rate by 424 to get the maximum rate at which the sender can send cells. Enter the rate in this field.

•Scr (Sustain Cell Rate) Rate. The average cell rate that can be transmitted, this value is normally less than the PCR value. Enter the rate in the field (if required by your service provider).

•Autodetect: Select Enable to have the settings automatically entered, or select Disable to enter the values manually.

•Virtual Circuit. These fields consist of two items: VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier). Your ISP will provide the correct settings for these fields.

•DSL Modulation. Select from the drop-down menu: Multimode, T1.413, G.dmt, or G.lite. The default value is Multimode. Your ISP may provide custom setting for this field.

When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes.

Chapter 4: Configuring the Gateway

Figure 4-8: Basic Setup Tab - Bridged Mode Only

22

The Setup Tab